Figure 15 High Pressure Cleaner Kdb 1240, Control Elements (Right Side) - Ehrle KD 823 Betriebsanleitung

High-Pressure-Cleaning-Systems
Figure 15
WARNING
CAUTION
NOTE
88
1 Gasoline tank
2 Motor switch On/Off
3 Unloader valve
High Pressure Cleaner KDB 1240, control elements (right side)
After pulling the starter grip (2, figure 16), the force of the water
leaving the nozzle causes a kick-back at the trigger gun. The
trigger gun and lance should be held firmly.
Handle the starter grip (2, figure 16) carefully. After pulling, the
starter grip must not snap back to the engine. Firmly lead the
starter grip back. Otherwise damage to the starter may result.
The High Pressure Cleaner should not run for more than 15
minutes in the bypass mode (trigger gun released). Otherwise
damage to the high pressure pump by overheating may result.
The throttle lever (1, figure 16) must not be adjusted manually, as
the motor speed control and adjustment is regulated automatically
by the idling control.