Removing The Temporary Stand - Sharp PN-655E Bedienungsanleitung

Removing the Temporary Stand

Follow the procedure below to remove the temporary stand.
• Before removing the temporary stand, prepare wall-hanging brackets to mount the monitor unit.
Read the manual of the brackets or stand for their mounting procedure. (The screw holes for
mounting brackets (M10 x 4 holes) are provided on the rear of the monitor. (See page 9.))
• The monitor must be installed or moved by two or more people.
1. Hold the monitor with the handles on the rear to
prevent it from falling down, and remove the upper
and lower stand fixing screws (4).
2. Lift the monitor by holding it with the handles
and the underside of the unit.
3. When the installation is complete, attach the
supplied stand hole protection covers as
necessary.
• The temporary stand is specifically designed for this monitor. Do not use the removed stand for other
devices.
• Store the removed screws together with the stand. You must use the original screws when you mount the
monitor onto the stand again. Using other screws could lead to a malfunction.
20
E
1. Fold the sheet
perpendicularly with
the adhesive side inward.
2. Remove the adhesive cover
and attach the sheet to the monitor.
(Rear view)