bürkert 0911 Bedienungsanleitung Seite 12

Digital inputs
HES Temperature increase/
Reduction
Function of the digital
i1F
Input
i1P Polarity of the digital
input
did Alarm delay time
of the digital input
(1...120 min)
Miscellaneous
Adr Serial address RS485
(1...247)
OnF Set device to STAND-BY
Number of the parameter-
Ptb
table
rEL Version
Pr2 Display of the parameters in display only
Level Pr2
NOTE You can access hidden paramaters by holding down the keys
SET +
appears.
10 - 0911
Set-value is increased/lowered by HES
during the energy saving phase.
EAL = external alarm; OFF = unused;
bAL = serious external alarm;
Es = Energy saving mode Start/Stop;
onF = switch the device ON/OFF
externally;
C-H = reverse the control effect
CL: active with closed contact
OP: active with opened contact
For i1F = EAL or i1F = bAL.
The corresponding alarm
display or message then takes place
Address for XJ500 recording
system. Identifies the device if it
is linked into a ModBUS-compatible
system.
no = not possible via keyboard
yes = STAND-BY can be activated by
holding down the SET button of at least
4 sec. During a STAND-BY, OFF is
displayed.
only read-out value
only read-out value
for 3 sec in the programming level HY. The message Pr2