Siemens TI355F09DE Gebrauchsanleitung Seite 51

The brewing unit cannot be
removed.
The appliance cannot be oper-
ated, display messages chang-
ing.
The grinder will not start.
Display shows "Close door"
despite door being closed.
Display shows: "Empty trays"
despite empty drip tray - what
to do?
Display shows "Fill water tank"
despite full water tank.
Display shows "Fill water tank"
and LEDs flashing.
The brewing unit is not in the
removal position (e.g. frost pro-
tection activated).
The appliance is in demo mode. Hold k button for at least 5 seconds
The appliance is too hot.
The door is not closed properly. Press the door firmly closed.
The appliance is too hot.
Emptying is not detected when
the appliance is off.
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Limescale deposits in the water
tank can block up the system.
Water tank is missing or not
inserted correctly.
The pipe system in the appli-
ance is dry.
Air in the water filter.
Trouble shooting en
Switch the appliance on again.
to deactivate demo mode. Remove the
water tank, fill with fresh water and
re-insert.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
When the appliance is switched on,
remove and re-insert the drip tray.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 42
Insert a new water filter.
Thoroughly clean the water tank and
start calc'nClean. ~ "Calc'nClean
service programme" on page 48
Insert water tank correctly.
Fill the water tank with fresh tap water.
Do not fill with carbonated water.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
51