Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Installation
Before the calling the nearest Authorized
Service for the installation of the dryer,
ensure that electrical installation and water
drain is appropriate referring to the user's
manual. (See 3.3 Connecting to the
drain and 3.5 Electrical connection) If
they are not suitable, contact a qualified
electrician and technician to make necessary
arrangements.
C
Preparation of the dryer's location
as well as the electrical and waste
water installations is the owners
responsibility.
A
Prior to installation, visually check
if the dryer has any defects on
it. If the dryer is damaged, do
not have it installed. Damaged
products cause risks for your
safety.
A
Let your dryer wait for 12 hours
before starting to use it.
3.1 Appropriate installation
location
Install the dryer on a stable and level surface.
Dryer is heavy. Do not move it by yourself.
•
Operate your dryer in a well ventilated,
dust-free environment.
•
The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and tape.
•
Do not cover the ventilation grills of the
dryer.
•
There must not be a lockable, sliding or
hinged door that may block the opening
of the loading door in the place where
your dryer is to be installed.
•
Once the dryer is installed, it should stay
at the same place where its connections
have been made. When installing the
dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
•
Place the dryer at least 1 cm away from
the edges of other furniture.
•
Your dryer can be operated at
temperatures between +5°C and +35°C.
If the operating conditions fall outside
of this range, operation of the dryer
will be adversely affected and it can get
damaged.
Dryer / User Manual
•
The rear surface of the tumble dryer
shall be placed against a wall.
B
Do not place the dryer
power cable.
3.2 Removing the
transportation safety
assembly
A
Remove the transportation safety
assembly before using the dryer
for the first time.
•
Open the loading door.
•
There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it
from its section marked with XX XX.
•
Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
Check that no part of the
transportation safety assembly
remains inside the drum.
on the
43 / EN
Werbung
Inhaltsverzeichnis
