Optional Accessories - Makita DUR365U Betriebsanleitung

Malfunction status
Motor does not run.
Motor stops running after a little
use.
It does not reach maximum
RPM.
Cutting tool does not rotate: stop
the machine immediately!
Abnormal vibration: stop the
machine immediately!
Cutting tool and motor cannot
stop: Remove the battery
immediately!
014837

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Cutter blade
• Nylon cutting head
• Nylon cord (cutting line)
• Plastic blade
• Protector assembly for nylon cutting
• Protector assembly for cutter blade
• Makita genuine battery and charger
16
Cause
Battery cartridges are not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Rotation is in reverse.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
Foreign object such as a branch is
jammed between the guard and the
nylon cutting head.
Cutter blade fastening nut is loose.
The cutter blade is bent.
The drive system does not work
correctly.
One end of the nylon cord has been
broken.
The cutter blade is bent, cracked or
worn.
Cutter blade fastening nut is loose.
Cutter blade is fastened improperly.
The drive system does not work
correctly.
Electric or electronic malfunction.
Install the battery cartridges.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Ask your local authorized service center for
repair.
Change the direction of ratation with the
reversing switch.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in
this manual.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Ask your local authorized service center for
repair.
Remove the foreign object.
Tighten the nut properly as described in this
manual.
Replace the cutter blade.
Ask your local authorized service center for
repair.
Bump the nylon cutting head against the
ground while it is rotating to cause the cord to
feed.
Replace the cutter blade.
Tighten the nut properly as described in this
manual.
Ask your local authorized service center for
repair.
Remove the battery cartridge and ask your
local authorized service center for repair.
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Action