Siemens TI35A Serie Gebrauchsanleitung Seite 24

en Trouble shooting
No coffee dispensed, only
water.
Coffee has no "crema".
The coffee is too "acidic".
The coffee is too "bitter".
The coffee tastes "burnt".
Milk/blended milk drinks too
hot.
Milk froth too thin, loud sucking
noise.
Milk/blended milk drinks too
cold.
The appliance is not dispensing
drinks.
Several buttons flashing, a loud
noise can be heard.
Water dripped onto the inner
floor of the appliance when the
drip tray was removed.
24
An empty bean container is not
detected by the appliance.
The coffee shaft on the brewing
unit is blocked.
Beans are not falling into the
grinding unit (beans too oily).
The brewing unit is not inserted
properly.
Unsuitable type of coffee.
The beans are no longer freshly
roasted.
The grinding level is not suita-
ble for the coffee beans.
Grinding level set too coarse.
Unsuitable type of coffee.
Coffee is ground too fine.
Unsuitable type of coffee.
Coffee is ground too fine.
Unsuitable type of coffee.
Too little milk in glass or cup.
Too much milk in glass or cup. Use less milk or adjust frothing time.
Milk in the glass or cup is too
cold.
Air in the water filter.
Water tank missing or wrongly
inserted.
Drip tray removed too early.
Add coffee beans
Note: The appliance will adjust to the
coffee beans on the next dispensing
process.
Clean the brewing unit. ~ "Cleaning
the brewing unit" on page 20
Gently tap the bean container.Possibly
change the type of coffee. When the
bean container is empty, wipe it with a
dry cloth.
Slide the brewing unit right back.
Use a type of coffee with a higher pro-
portion of robusta beans.
Use fresh beans.
Set a finer grinding level.
Set a finer grinding level.
Use a darker roast.
Set a coarser grinding level.
Change the type of coffee.
Set a coarser grinding level.
Change the type of coffee.
Use more milk or adjust frothing time.
Use lukewarm milk.
Immerse the water filter in water until
no more air bubbles escape; insert the
filter again.
Firmly press the water filter straight
down into the tank connection.
Insert water tank correctly.
Wait a few seconds after the last drink
was dispensed before removing the
drip tray.